• Join over 1.2 million students every month
  • Accelerate your learning by 29%
  • Unlimited access from just £6.99 per month

IDENTIFICATION OF AN ORGANIC compound

Extracts from this document...

The above preview is unformatted text

This student written piece of work is one of many that can be found in our AS and A Level Organic Chemistry section.

Found what you're looking for?

  • Start learning 29% faster today
  • 150,000+ documents available
  • Just £6.99 a month

Not the one? Search for your essay title...
  • Join over 1.2 million students every month
  • Accelerate your learning by 29%
  • Unlimited access from just £6.99 per month

See related essaysSee related essays

Related AS and A Level Organic Chemistry essays

  1. Comprehensive and Detailed Chemistry notes

    amount of heat released by the complete combustion of one mole of a substance -- The molar heat of combustion is expressed in KJ/mol -- In a plentiful supply of oxygen, alkanols burn completelyto produce carbon dioxide and water The complete combustion of ethanol is shown below: C2H5OH(l)

  2. Identifying An Unknown Compound

    Take the boiling tube and add to it 2cm3 each of ethanol, compound X, and the concentrated sulphuric acid. Place the boiling tube in the beaker full of hot water, and wait for several minutes. Waft the air above the boiling tube towards your nose, and try to detect the

  1. Identification of an unkown compound

    Hazards: Bromine water can be toxic and corrosive, so gloves must be worn and care taken. Extreme care must be taken when dealing with Phenol, direct contact with skin can cause severe burns, so gloves must be worn at all times.

  2. Identification of an unknown organic compound.

    * However ketones cannot be gently oxidised; instead they are only oxidised through combustion. Reason being if a ketone was to be oxidised it would require enough energy to break a C-C bond as opposed to that in an aldehyde which requires less energy to break a C-H bond to be oxidised to a carboxylic.

  1. Identification of an Unknown Organic Compound

    Always work in the fume cupboard because inhaling the fumes can damage the respiratory system. Seek immediate medical attention if any contact with the chemical is made.ii * Acetone is only very slightly toxic and not much harmful. If an eye or skin contact is made then rinse with water immediately.

  2. Identification of an unknown Organic Compound

    Positive results will show carbon dioxide produced. This is because the general equation is; Carboxylic acid + Metal Carbonate Salt + Water + Carbon dioxide However, to test for CO2, I will use the limewater test. Limewater, Ca(OH)2 will react with CO2 to form white precipitate, CaCO3, and water.

  1. IDENTIFICATION OF AN ORGANIC UNKNOWN

    Seek medical attention as soon as possible. If inhaled, remove victim and put where there's fresh air. If chemical gets into eyes, wash off with plenty of water and seek medical help. Wear eye protection, and wear gloves during handling of chemical.

  2. Qualitative Analysis (A combined approach using spectroscopic and chemical analysis for structural identification of ...

    The sodium metal was warmed and was allowed to run into the organic compound when it melted. Then it was heated gently until there was no more flame. After that the tube was held vertically and the mixture inside was heated to red-hot.

  • Over 160,000 pieces
    of student written work
  • Annotated by
    experienced teachers
  • Ideas and feedback to
    improve your own work