• Join over 1.2 million students every month
  • Accelerate your learning by 29%
  • Unlimited access from just £6.99 per month

To find out how temperature will effect the rate of reaction between sodium thiosulphateand hydrochloric acid.

Extracts from this document...

Introduction

Lewis Brend Friday. 28 September 2001 Rates of Reaction Aim: To find out how temperature will effect the rate of reaction between sodium thiosulphate and hydrochloric acid. Apparatus: Stop-clock Conical flask Thermometer Beaker Tripod Gauze Bunsen Burner Paper with a cross on it Safety Specs Heat Mat Measuring Cylinders Sodium Thiosulphate Hydrochloric Acid Prediction: My prediction is that the ...read more.

Middle

Light the Bunsen burner and fill a beaker with 100ml of water, then measure 20ml in a measuring cylinder and put into a conical flask. Put the conical flask in with the beaker. Keep checking the temperature by using a thermometer. ...read more.

Conclusion

Once it has gone this colour stop the sop-clock and take note of the time. Then do this for the rest of the temperatures. This will be made a fair test by not stirring the acids and by doing the exact same procedure to the other tests. Doing this will make it a fair test. Results: Temperature Time Taken 20� 131.16 30� 82.63 40� 31.02 50� 31.16 60� 24.55 70� 15.95 ...read more.

The above preview is unformatted text

This student written piece of work is one of many that can be found in our GCSE Aqueous Chemistry section.

Found what you're looking for?

  • Start learning 29% faster today
  • 150,000+ documents available
  • Just £6.99 a month

Not the one? Search for your essay title...
  • Join over 1.2 million students every month
  • Accelerate your learning by 29%
  • Unlimited access from just £6.99 per month

See related essaysSee related essays

Related GCSE Aqueous Chemistry essays

  1. Marked by a teacher

    To investigate the effect of temperature on the rate of reaction

    4 star(s)

    Measure out 30ml of hydrochloric acid. 6. Add it quickly to the conical flask, closing the stopper straight away and starting the stopwatch immediately. 7. Every 5/10 seconds, record the amount of gas that has built up in the syringe; until it reaches 100, at which we stop the experiment.

  2. The Rates of Reaction of Metals with Acid.

    I would also go as far as saying, if I experimented on the order of phosphoric acid, it would be an order of three, this is because its basisity is three. This is Type of Acid Molecular Formula Basicity Level Order of reaction Hydrochloric HCl Mono 1 Sulphuric H2SO4 Di 2 Phosphoric H3PO4 Tri 3 Ethanoic CH3CO2H Mono (organic acid)

  1. Investigation to find out how the rate of reaction between sodium thiosulphate and hydrochloric ...

    clean and free of any water or any other substance before we attempt to start the next experiment. Safety There are a lot of safety issues we must abide by in this experiment also. We must remember that the substances that we use in this experiment can be very harmful if used the wrong way.

  2. Investigation to find out how the rate of reaction between sodium thiosulphate and hydrochloric ...

    We must make sure that coats and bags are all out of the way while doing the experiment. Ties and hair should be tucked out of the way, so they do not make contact with any of the chemicals. It would also be preferable to wear a scientific apron, however this is not essential.

  • Over 160,000 pieces
    of student written work
  • Annotated by
    experienced teachers
  • Ideas and feedback to
    improve your own work