The project we did was a project on printing, we had to first gather images and other drawings to stick on a piece of paper, which the print will be based on.
Art
The project we did was a project on printing, we had to first gather images and other drawings to stick on a piece of paper, which the print will be based on. After this we had to draw some of our own ideas either copied or made up to go with our pictures and to go with our theme eg. good pictures to go with a theme of kindness or on the other hand bad pictures to go with a theme of evil. After we had done all this with a set theme on a piece of paper we traced it, then we stuck the tracing face down on some linocut and traced off harder so the pencil line showed up on the linocut. Then we cut out the lines that appeared on the linocut with a gauge identifying which parts we were going to colour our light, medium and dark colours. After that we printed the light colour we gauged out the light bit and were left with the medium and dark bits, after we printed the medium colour on the light coloured print we gauged out the medium bits and then we went over the medium and light coloured prints with the dark colour giving us a final print with light, medium and dark coloured bits giving the 2D print a sense of tone and shading.
The project we did was a project on printing, we had to first gather images and other drawings to stick on a piece of paper, which the print will be based on. After this we had to draw some of our own ideas either copied or made up to go with our pictures and to go with our theme eg. good pictures to go with a theme of kindness or on the other hand bad pictures to go with a theme of evil. After we had done all this with a set theme on a piece of paper we traced it, then we stuck the tracing face down on some linocut and traced off harder so the pencil line showed up on the linocut. Then we cut out the lines that appeared on the linocut with a gauge identifying which parts we were going to colour our light, medium and dark colours. After that we printed the light colour we gauged out the light bit and were left with the medium and dark bits, after we printed the medium colour on the light coloured print we gauged out the medium bits and then we went over the medium and light coloured prints with the dark colour giving us a final print with light, medium and dark coloured bits giving the 2D print a sense of tone and shading.