Internal Resistance of a cell
Topic: Internal Resistance of a cell Aim: To measure the internal resistance and emf (the potential differences across a voltage Source when no current is flowing) and to observe the combination of cells Hypothesis: The emf of the old cell is less than the emf of the new cell but the internal resistance of the old cell is much greater than the new cell. Introduction: Resistance in electricity, property of an electric circuit or part of a circuit that transforms electric energy into heat energy in opposing electric current. Resistance involves collisions of the current-carrying charged particles with fixed particles that make up the structure of the conductors. Resistance is often considered as localized in such devices as lamps, heaters, and resistors, in which it predominates, although it is characteristic of every part of a circuit, including connecting wires and electric transmission lines. (Britannica.2006) The dissipation of electric energy in the form of heat, even though small, affects the amount of electromotive force, or driving voltage, required to produce a given current through the circuit. In fact, the electromotive force V (measured in volts) across a circuit divided by the current I (amperes) through that circuit defines quantitatively the amount of electrical resistance R. Precisely, R = V/I. Thus, if a 12-volt battery steadily drives a 2-ampere
Measurement of the resistivity of Nichrome
Measurement of the Resistivity of Nichrome (NiCr) Introduction In this coursework, I am going to measure the resistivity of Nichrome. Nichrome is a non-magnetic alloy of nickel and chromium. It is a good conductor of electricity and heat, and has a high melting point. Due to its relatively high resistivity and resistance to oxidation at high temperatures, the wire made of Nichrome is widely used in heating elements, such as in hair dryers, electric ovens and toasters. What does Resistivity mean? Resistivity (also known as electrical resistance) is a measure of how strongly a material opposes the flow of electric current. It is normally static and could be varied by changing the temperature. In general, resistivity of metals increases with temperature, while the resistivity of semiconductors decreases with increasing temperature. High values of resistivity imply that the material making up the wire is very resistant to the flow of electricity. Low values of resistivity imply that the material making up the wire transmits electrical current very easily. The unit of resistivity is the ohm meter (? m). The resistivity ? (rho) of a material is given by > ? is the static resistivity (measured in ohm metres, ?·m); > R is the electrical resistance of a uniform specimen of the material (measured in ohms, ?); > L is the length of the piece of material (measured in
Sensing project
Sensing project Project brief A new greenhouse is being developed for gardeners who are concerned about overheating plants in their current greenhouses. The new greenhouse has been built with opening windows but occasionally the windows of the greenhouse slips fully open and allow all of the trapped heat in the greenhouse to escape quickly. This is a major concern for serious gardeners. The test is to develop a sensing circuit that will sense whether the windows are fully open, so a gardener can be alerted of the problem. Introduction To begin we must know what a sensor is. A sensor is an electrical component, which produces a signal in response to alteration in its surroundings, this maybe an alteration in a physical variable or by movement of objects. The sensor planned for the sensing circuit ensuring the windows are not fully open is a rotary potentiometer. A rotary potentiometer is a component, which has three terminals. When the angle of rotation is changed on the component's arm then the potential difference (often called voltage) is also changed. Once the voltage reaches a specific point a separate circuit could activate an alarm showing that the window has slipped and is fully opened. The potential difference is the difference between potential energy between two separate points. Alternatively a different sensing circuit could be used. A circuit with
