To determine the water potential of a potato tuber cell using varying salt solution.
Aim To determine the water potential of a potato tuber cell using varying salt solution. Introduction Osmosis is the diffusion of water molecules from a region where it has higher water potential to a region where it has lower water potential through a partially permeable membrane1. As osmosis is a type of diffusion the same things that affect diffusion have an effect on osmosis some of theses things are: * The concentration gradient - the more the difference in molecules on one side of the membrane compared to the other, the greater the number of molecules passing through the membrane and therefore the faster the rate of diffusion2. * The surface area - the larger the area the quicker the rate of diffusion * The size of the diffusing particles - the smaller the particle the quicker the rate and polar molecules diffuse faster than non-polar ones3. * The temperature - the higher the temperature the more kinetic energy the particles have and so the faster they move. From the diagram4 we can see the process of osmosis in a simple expression. On the right side there is pure water, which has the maximum water potential of 0. Water potential is the pressure created by water. As you can see from the diagram the pure water is pushing its way through the semi permeable membrane at a high pressure. This is its water potential. Water potential is measured in kilopascals (kPa)
Catholic discrimination in Northern Ireland in terms of Housing and Employment
There has been a long history of violence, prejudice, and discrimination between Catholics and Protestants in Northern Ireland, particularly highlighted throughout the 1960s, when Catholics were discriminated against by the Protestant Stormont Government in both employment and housing. Hence, in order to understand in what ways and how much it occurred, both these areas must be investigated. Firstly, one must look at how the Catholics were discriminated against in terms of employment, and to what extent this occurred. In the public sector, Catholics suffered great difficulties being employed, as there appears to have been some bias towards employing Protestants, especially in senior levels of the civil service. For example, in a report by the Cameron Commission in 1969, it is stated, "[As of October 1968] In County Fermanagh, no senior council posts, (and relatively few others) were held by Catholics" and according to the Sunday Times, in the same county, in 1961 "322 of the [370] posts, including the top ones, were filled with Protestants. This shows how during the 1960s, the Catholics in Fermanagh did not have many jobs at a high level in the public sector. This is particularly interesting because the majority of people in Fermanagh were Catholics, hence highlighting the extent of their discrimination. The Sunday Times also wrote that in Derry "of 177 salaried employees,
How the structure of cells is related to their function.
How the structure of cells is related to their function. All living things are made up of cells, whether its plants, humans or even bacteria. There are two different types of cells one is the prokaryotic and the other is the eukaryotic. The name cell was used by an English man who in 1665 use the first microscope and reported seeing what he described looked like the sleeping chambers in the monasteries that were called cells, in a piece of cork.1 The first of the two types is the Prokaryotic cell, the pro meaning before the nucleus as this cell has no true nucleus.2 Prokaryotic cells are surrounded by a cell wall and a cells membrane, and in some ways this makes them similar to a plant cell which is eukaryotic, but they have no nucleus or organelles inside, but they do have flagella's and cilia on the outside. The flagellum is a long whip like tail attached to the end of the prokaryotic cell which helps with its movement. The cilia are small spiked hairs that help to transport fluid in and out of the cell and for protection against harmful substances. They are also found in abundance in the eukaryotic cells in the human trachea where they collect dirt, they either by moving it down into the stomach or push it back up into to the mouth to spit it out.3 One of the most common prokaryotic cells would be bacteria, they are the smallest cellular organism, and each human being
Outline the development of attachments
Developmental Psychology - Key Assessment Task a) Outline the development of attachments An attachment is a powerful bond between an infant and its caregiver. Infants form attachments because they are helpless at birth and so need caregivers to provide for and protect them. There are many long term effects of attachments, for example an attachment gives a foundation for emotional relationships e.g. the infant is learning how to form an emotional or "love" relationship. Schaffer and Emerson believed that infants form attachments by three stages, this argument was based on a large scale study of 60 infants in a working class area of Glasgow over 2 years. The first stage of attachment Schaffer and Emerson believed a child to go through happens when they are 0-6 weeks old, this is known as the Asocial Stage and involves the infant smiling and crying but not directing these emotions at individuals. The second stage of attachment is known as Indiscriminate Attachment and happens when the infant is 6 weeks to 7 months old; this involves the child seeking attention from different individuals. The last stage of attachment is Specific Attachments and happens when the infant is 7-11 months old, this stage shows a strong attachment to one individual, with good attachment to others following afterwards. b) Describe the procedures and findings of one study of individual difference in
Investigate the water potential of celeriac.
Aim Investigate the water potential of celeriac. Apparatus Celeriac - this is the specimen that we will be finding the water potential of. .00 mol dm-3 sucrose solution - this will be placed in the test tube in which the experiment will take place. We will dilute the solution to produce a range of concentrations. 0.0ml Graduated Pipettes (x2) - I had a choice of 5.0ml, 10.0ml and 20.0ml graduated pipettes. I chose this size pipette because it is time efficient and accurate at the same time. It is an accurate piece of equipment because as opposed to standard pipettes, this graduated pipette has 0.1ml graduations to ensure the utmost accuracy. One pipette will be used for water and one will be used for sucrose solution. 250ml Beakers (x2) - these will be used to hold water and the 1.00 mol dm-3 sucrose solution in a safe environment. Cork Borer - this will be used to cut the precise shape of the celeriac. This will also ensure that the surface area to volume ratio is constant throughout the experiment. Razor - this will be used to cut the pieces of celeriac to a precise length. Ruler - this will be used to measure the length of celeriac that will be used in the experiment. Scales - they will be used to measure the mass of celeriac before and after the experiment with accuracy. Therefore, the mass increase/decrease can be calculated after the experiment. These scales
Preparation of propanone from propan-2-ol
Date: 11/10/2011 Exp. No.: 23 Title: Preparation of propanone from propan-2-ol Aim: The aim of this experiment is to prepare propanone by oxidizing propan-2-ol with acidified potassium dichromate solution. Introduction: Ketones and aldehydes are important series in preparation of other compounds and they are commonly prepared by oxidizing alcohol which is done in this experiment. The experiment is an oxidation reaction where a secondary alcohol (propan-2-ol) is oxidized by acidified potassium dichromate. The reaction does not need to be heated but should be placed in an iced water bath as the reaction is highly exothermic. The product is propanone and no catalyst is needed for the reaction. The propanone is serparated from the reaction mixture by simple distillation and is purified using anhydrous cacium chloride. The equation of this reaction is as follow: Chromic acid is produced in situ by adding potassium dichromate (VI) with sulphuric acid and water. K2Cr2O7 + H2O + 2H2SO4 ? 2 H2CrO4 + 2 NaHSO4 The term chromic acid is usually used for a mixture made by adding concentrated sulfuric acid to a dichromate, which may contain a variety of compounds, including solid chromium trioxide. Chromic acid features chromium in an oxidation state of +6. It is a strong and corrosive oxidising agent. Apparatus and chemicals: Apparatus: Quick-fit distillation setup,
Write an essay on electrode potentials.
F7 Essay Writing (Electrode Potentials) Q. Write an essay on electrode potentials. Outlines: (I) What are electrode potentials? (a) associated with equilibria of redox systems (half cells): e.g. metal / metal ion system ; non-metal / ion system ; ion / ion system; (b) reactivity, tendency for reduction to occur (losing electrons) and potential difference; (c) the potential difference of a half cell cannot be measured alone, but a relative value could be measured with another reference half cell / reference electrode; (d) a standard hydrogen electrode [SHE] (in which the emf is defined as zero) is used as the reference electrode; (II) How are electrode potentials measured? (a) concentration, temperature and pressure affect the emf of SHE, and the standard electrode potentials are obtained under conditions of 298K, 1 atm and conc. of 1M. (b) set up a cell with SHE and a salt bridge of electrolyte (e.g. KNO3); (c) a potentiometer is used to measure the cell emf (maximum potential difference), and the sign of cell emf = polarity of the right hand electrode. (III) How are electrode potentials used? / Application of electrode potentials? (a) calculation of cell emf ; (b) prediction of reaction feasibility and limitations. ~ Sample Essay ~ An electrode potential is the difference in an potential between an electrode and its surrounding electrolyte. It is
Artificial Cardiac Pacemakers
Research questions : Why is the constant beating of the heart important? What causes the heart to beat abnormally? What are the implications of having an abnormal heart beat? What is an artificial pacemaker and how does it regulate an abnormal heart beat? How are artificial pacemakers implanted? What are the advantages and disadvantages of using an artificial pacemaker? What are some alternatives used instead of artificial pacemakers? The importance of the heart The heart is an essential organ possessed by every living human. It is vital as it pumps blood rich in oxygen (received from the lungs) to every living cell within the body and pumps deoxygenated blood to the lungs (from the body)1. In the opposite diagram of a human heart, the blue sections represent the transport of deoxygenated blood and the red sections represent the transport of oxygenated blood. The heart is necessary in sustaining the lives of every single human being. This is because without oxygen, cells cannot carry out the process of cellular respiration (the release of energy from glucose). This means that the body cells will have insufficient energy to carry out regular functions needed for sustaining life. Every single cell in the human body is affected by the beating of the heart, as enough oxygen has to be supplied for them to function properly. Without the constant beating of the heart,
How do individual differences influence stress levels?
How do individual differences influence stress levels? The extent to which stress can affect a person is largely dependant on the type of personality they possess. An individual with a Type A personality is categorised as having aggressive tendencies combined with being a competitive high achiever with a fixation on time management. It is thought that these types of traits lead to increased stress levels and blood pressure, which in turn increase the possibility of developing coronary heart disease (CHD). This theory was tested by Friedman and Rosenman in the Western Collaborative Group Study (1960). They used around 3000 middle aged men that lived in California, and tested them for indicators of CHD before assessing their personality. After eight years they found that twice as many participants diagnosed as Type A died of cardiovascular trouble than those diagnosed as Type B (personalities lacking in the traits characteristic of Type A). It was also found that Type As are more likely to smoke and had higher blood pressure and cholesterol levels, all of which are causes of cardiovascular problems. This does show a correlation between this type of personality and stress related death, but not a definite cause and effect. The experiment also does not take into account that many Type As had a family history of cardiovascular problems, which is indicative of genetic condition
Revision Notes. Substances Manufactured for use in Industries. Chemicals, alloys and polymers.
.1 Manufacture of Sulphuric Acid Uses of Sulphuric Acid Sulphuric Acid, H2SO4, has many uses in our daily life. A few examples are: (a) Manufacture of fertilisers such as ammonium sulphate, (NH4) 2SO4 (b) Manufacture of electrolyte in lead-acid accumulators (c) Manufacture of soaps and detergents (d) Manufacture of pesticides (insecticide) (e) Manufacture of plastic items such as rayon and nylon (f) Manufacture of paints Manufacture of Sulphuric Acid in industry . Sulphuric acid, H2SO4, is manufactured in industry through the Contact Process. 2. The manufacturing of sulphuric acid, H2SO4, in industry involves three stages. Stage Aim Stage 1 Sulphur dioxide, SO2, gas can be produced by burning sulphur in air. S + O2 SO2 To produce sulphur dioxide, SO2, gas Stage 2 The gas mixture of sulphur dioxide and oxygen is passed over vanadium(V) oxide, V2O5 (catalyst) at a temperature of 450-500 ºC and under pressure of 1 atmosphere. 2SO2 + O2 2SO3 To produce sulphur trioxide, SO3 gas Stage 3 Sulphur trioxide, SO3, gas is dissolved in concentrated sulphuric acid, H2SO4 to form oleum, H2S2O7. SO3 + H2SO4 H2S2O7 Water is then added to the oleum, H2S2O7 to dilute it to produce sulphuric acid, H2SO4. H2S2O7 + H2O 2H2SO4 To produce sulphuric acid, H2SO4 The three stages involved in the Contact process Environmental
